Tuesday, 16 April 2013

Ring Bearer Pillow for Lisa's Pooch





Following are pics of a ring bearer pillow requested by Lisa.  The bone measures 4-3/4 inches across (I can't believe I was able to make it this small!) There's a loop at the top to tie it to the dog's collar, but in this case the pooch is very tiny so it can be tied to a ribbon that will fit around the body. The wedding rings are tied using the ribbon below the flowers.

The flowers aren't stitched on yet so that one of the two proposed models below can be selected.

1) My favourite - an ivory satin ribbon rose surrounded by two purple satin ribbon roses. There are tiny sheer bows with pearl centers at each end.


CLICK ON THE PHOTOS TO ENLARGE!





2) Same as above only the center ivory rose is replaced with another purple satin ribbon rose.





In this photo I'm holding the ring pillow to give relevance of the size.